This option will prompt the user to create a new command repeater data file.
This option will prompt the user to select and existing command repeater data file.
This option will prompt the user to save the current command repeater data file.
This option will switch the Command Repeater widget into edit mode.
|Configure||This option will open the Command Repeater run-time settings|
|Start||This option will start/resume sending commands from the Command Repeater to the active terminal session.|
|Stop||This option will stop sending commands from the Command Repeater to the active terminal session.|
|Pause||This option will pause/resume sending commands from the Command Repeater to the active terminal session.|
|Enabled||This option allows you to enable/disable specific variables.|
|Variable||This field defines the variable replacement name/token. To embed a variable in command data, please see Command Variable Replacement|
|Start||This field defines the seed value or initiating start value that the variable will be assigned when the Command Repeater cycle starts.|
The variable value will always be rest to this start value when the Command Repeater is re-started.
|Operator||This field defines the math operation to perform on each repeater cycle. The Command Repeater can perform addition, subtraction, multiplication, and division.|
|Cyclic||This field defines the operand value to use in the equation on each repeater cycle.|
|Current||This field displays the current value derived from the equation after each cycle.|
You can pause the Command Repeater and modify a variable's current value, operator, cycle operand, etc. and resume the repeater cycle.
You can also use variables defined in the Variable Manager with commands listed in the Command Repeater.